Nylon Chute 9"
Nylon Chute 36"
Chute Release 5X
Chute Release lets you control the altitude your parachute opens.For model rocketry.
For high-altitude launches that descend over high terrain, try these versions:Chute Release 5XChute Release 10X
FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint.
Pick-up at Launch
Nylon Chute 15"
Nylon Chute 24"
Motor Pickup Request - Teams Only
Nylon Chute 50"
75mm Flush Aft Closure - 75FACC
75mm "No Smoke Charge" Plugged & Threaded Forward Closure - 75FCPTNS
J550ST-14 RMS-54/852 Reload Kit (1 Packå) - 105514 (Was J615ST20A RMS-54/852 - 106120)
75mm Tail Cone Flush Aft Closure - 75TFAC
SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of our epoxies. It is waterproof and more heat resistant. SLOW-CURE™ can be used for bonding if you’re willing to wait overnight. Fillers such as microballoons can be mixed with SLOW-CURE™ and FINISH-CURE™ to form a putty-like consistency. Such fillers will usually decrease the working time by about 25%. Bonded objects can be handled after 8 hours and the cured epoxy reaches full strength within 24 hours.
MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed. It is more water resistant and can be used as a substitute for QUIK-CURE™ in most applications. MID-CURE™ is our most flexible epoxy and is ideal for gluing to fiberglass surfaces. Allow 45 minutes before handling parts and 2 hours for full strength.
QUIK-CURE™ 5 min. epoxy cures to a slightly flexible consistency.
Bulk pack of 252 starters, includes HazMat shipping
For use with “M” or larger motors.
Approximate measurements: 1 1/4 inches long by 19/64 inch (.297) OD with 60-inch leads.
Request a Rental Jolly Logic Altimeter Two for a Launch.
Cardboard 2.6 x 18.5" Tube
This engine set is a great alternative to the standard engine hook. Three complete sets included.
