Model Rocket Display stand for all of your C11, D & E engine size model rockets!
3 to a pack. What a great value!
Featherweight Tracker Battery 400mAhr
MicroSplash is a barometric logging altimeter for precision model rocketry altitude measurements, that weighs less than 2 grams including the battery!.
The hardware is identical to MicroPeak, but this version has firmware that is optimized for use with water rockets, with a more sensitive boost detect of 10m instead of the 30m used by MicroPeak.
Model Rocket Display stand for all of your mini engine size model rockets!
Provides a built-in connector for your Raven. Just tighten the Raven's screw terminals, plug in the battery, and the electrical connections are done!
Featherweight 915 MHz Antenna
The magnetic switch is reliable and easy to use in any rocket installation without needing any exterior holes to be drilled or aligned.
The Blue Jay altimeter is the easiest rocketry altimeter to install and use.
Note: the Blue Jay altimeters will not arrive before Christmas
Rare-Earth permanent magnet for use with magnetically-activated switches and av-bays.
Rare-Earth permanent magnet for use with magnetically-activated switches and av-bays. The standard magnet is easy to use and has a range of about 1".
This board is designed for in-flight characterization of research rocket motors. It records chamber pressure and acceleration to an on-board flash memory chip, the contents of which can be downloaded after flight over USB.
0-1600 psi pressure sensor, with "Buick" style connector and analog output.
These sensors take 5V DC in and give an analog voltage out that ranges from 0.5 volts at 0 psi to 4.5 volts at the full scale of 1600 psi. The sensor body is stainless steel, and the input fitting is a male boss threaded 1/8 inch NPT. These sensors are ideal for use in high power rocket motor characterization, and directly connect to our motor characterization boards.
This kit consists of 5 pieces each of
These batteries are approximately 0.25x1.2x2.0" (6x30x48mm), and weigh about 19g (0.67oz).
This is a battery clip with 12 inch (30.48cm) wire leads. If you want to attach a 9V alkaline battery to an EasyMini or other flight computer, this will do the trick.
You can buy 9V battery clips elsewhere, what makes these "interesting" is the long leads. You can trim them to fit in nearly any avionics bay design!
These batteries are approximately 4x15x30mm, and weigh 3.6g.
These batteries are approximately 0.2x1.0x1.4" (5.5x25x35mm), and weigh about 9.5g (0.33oz).
