If your display is cracked or damaged, you can snap in a replacement
Rocket Print Crew Socks
As you may have already heard, some Aerotech motors are being discontinued.
Pre-orders are open now through April 15th. After that, we cannot guarantee any availability.
All orders placed will be fulfilled from this final batch, which Aerotech expects to ship as they become available over the next year, as late as April 2027.
AeroTech RMS-75/2560-6400 System Motor Hardware Set - 7525S
FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.
ENGINES FOR MODEL ROCKETS
3 – E12-0 Engines 4 – Starters 4 – Starter Plugs
ATTENTION: Additional Hazardous Materials shipping and handling charge of $35.49 will be applied at checkout.
ATTENTION: These engines cannot be sent to post office boxes. Please be sure to provide a PHYSICAL ADDRESS when purchasing E and F sized engines.
Preorder Only; Aerotech lead time is over 4 weeks. AeroTech RMS-98/7680 Complete Motor Hardware Set - 9876M
Quest Q-Jet(tm) D16-6FJ Black Max Complete 2-Motor Launch Pack - Q6121
Super-Gold is a thin viscosity foam-safe cyanoacrylate glue that is (nearly) odorless, and does not frost nearby surfaces as it cures. Curing time is 2 or 3 seconds longer than traditional CA glues of similar viscosity, but the slower cure time and different formulation prevent the sudden heating that can damage foam surfaces as CA glue cures. You can use Insta-Set CA Glue Acclerator in a very fine mist to speed cure time, but do not apply too much accelerator, or you may damage foam surfaces.
