The Very Versatile Viking is everyone’s favorite research rocket to use with classroom investigations. This rocket has 48 possible fin configurations that can be used for it. Students can hypothesize how their fin arrangement will affect the rocket’s flight then put it to the test by launching it. The Viking is the perfect, low cost rocket for slim budgets.
Onebadhawk Harness 3/8" x 30ft Tubular Kevlar Harness with 3 sewn loops
The Snap Mount for AltimeterOne, AltimeterTwo, and AltimeterThree.
The Snap Mount makes it easy to mount your altimeter quickly and securely. Made of strong polypropylene, these mounts are built to be tough. Just insert the nose of your altimeter under the clip, then press the other down until it snaps securely. To release, you spread the snaps apart to release the altimeter.
Just slightly wider, longer, and higher than the altimeter itself, and very light (weighs just 4 grams).
Kit includes screws, nuts, and bolts that work on a variety of materials. Also includes hook-and-loop strap that you can trim with scissors to fasten the mount to fuselages, struts, and landing gear.
Note: Fits current generation of altimeters, but does NOT fit altimeters manufactured before 2014 (see our Support page to figure out which you have).
Onebadhawk Harness 1/4" x 25ft Tubular Kevlar Harness with 3 sewn loops
GIZMO
This fun and easy to build “itty-bitty” rocket really scoots through the sky! The 220 Swift is sleek and launches on mini engines then tumbles back to earth.
High quality spiral wound paper tube for kits using the BT-50 body tube.
Super-Gold is a thin viscosity foam-safe cyanoacrylate glue that is (nearly) odorless, and does not frost nearby surfaces as it cures. Curing time is 2 or 3 seconds longer than traditional CA glues of similar viscosity, but the slower cure time and different formulation prevent the sudden heating that can damage foam surfaces as CA glue cures. You can use Insta-Set CA Glue Acclerator in a very fine mist to speed cure time, but do not apply too much accelerator, or you may damage foam surfaces.
The Sidekick cleverly combines two body tubes, two nose cones, and two sets of fins to produce one remarkable rocket! Clustered engine launches are spectacular, as are recoveries via twin 36-inch mylar streamers. Light up the sky with the dynamic dual delights of the Estes Sidekick!
The Orange Bullet is the first release in the Estes Designer Signature Series. This series will re-introduce lesser known classics and launch never-before seen designs by some of the most famous pioneers of the model rocket industry. The Introductory rocket was designed by none other than Vern Estes himself!
A high quality spiral wound paper tube for kits using the BT-20 body tube.
Onebadhawk Harness 3/8" x 25 Ft.ft Tubular Kevlar Harness with 2 sewn loops
1.6" Mini Black Brant II
