An upsized replica of the #1 selling Hi-Flier! Powered by Estes C11, D and E model rocket engines, amazing heights can be reached!
NC-5 Nose Cone will fit BT-5 body tubes.
If your display is cracked or damaged, you can snap in a replacement
Super-Gold is a thin viscosity foam-safe cyanoacrylate glue that is (nearly) odorless, and does not frost nearby surfaces as it cures. Curing time is 2 or 3 seconds longer than traditional CA glues of similar viscosity, but the slower cure time and different formulation prevent the sudden heating that can damage foam surfaces as CA glue cures. You can use Insta-Set CA Glue Acclerator in a very fine mist to speed cure time, but do not apply too much accelerator, or you may damage foam surfaces.
The Sidekick cleverly combines two body tubes, two nose cones, and two sets of fins to produce one remarkable rocket! Clustered engine launches are spectacular, as are recoveries via twin 36-inch mylar streamers. Light up the sky with the dynamic dual delights of the Estes Sidekick!
The Orange Bullet is the first release in the Estes Designer Signature Series. This series will re-introduce lesser known classics and launch never-before seen designs by some of the most famous pioneers of the model rocket industry. The Introductory rocket was designed by none other than Vern Estes himself!
It’s not real, but it certainly looks like it could be! The Terra GLM represents the possible future of military ground launch vehicles. This easy-to-assemble model comes with parts pre-finished in a military color scheme – no sanding or painting required! Build and fly this model in the same day.
NEW LOWER PRICE! Make your Pro Series II E2X rockets go REALLY high!
Lithium Polymer replacement battery for newer generation AltimeterOne, AltimeterTwo, AltimeterThree, and Chute Release
FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.
